66071-001 Rev 02 @ Z Wave* PI ii HOME ave® Plus [OT el 4 CONNECT : TOUCH PAD ELECTRONIC DEADBOLT Installation and User Guide Required tools mmm Thickset Ruler Phillips head screwdriver Technical Support Additional Tools depending on application) 1-866-863-6584 wwwkwiksetcorm Hammer Greene Parts in the box Exterior Interior Assembly Assembly TBs not included. If headed, Mounting Fasteners lens contradistinction | Plate Adrian or rnc.
H Install the exterior keypad A Insert cylinder into keypad. C€ Install exterior keypad and mounting plate, © | Asama Andy during mounting piste affiliations. Locate screws and keep them within reach. B | Wheatstone diameter of the hole In the door? Diameter is 21/8" Diameter is ‘Route cable through (Grimm) (38 mm) center hole, then push cable Into side hole. Kemp para to periodontal Insert key and 4 test latch. If arch “D* is required for installation. “Dla not needed for Install “D" on “F". installation.
a Add the lock to your smart home system A Initiate the process to add the lock to your system at Your smart home controller. Refer to your smart home system Instructions for more information, B | When prompted by your smart home system to add the lock; press button “A” on the lack inferior one ime; The red LED will Inseminate when the lack enters Arid Mode.
Reference Guide Smart Code at a Glance Exterior Interior (cover removed) Back Button "8" Smart Key tool hole System Alerts Alert Reason Solution Keypad freshened time Door jammed while Manually re-rock door. If needed, with 1 beep attempting to lock. reposition strike. Unsuccessful programming. pews programming procedure Keypad flashes red 3 times ~ with 3 beeps® One incorrect code entered. Re-enter aced. Mouser coda programmed.