© CSS — pass [Select] key — choose the CSS code by key ~ press [Select] key to confirm — “Set OK” pops up on the screen and rectums to the previous veal; < DCS — press [Select] key — choose the DCS code by key —~ press [Select] key to confirm — "Set Ok" pops up on the screen and rectums to the previous level; < DCS Reverse — press [Select] key — chooses the DCS Reverse code by [A/W] key — press [Select] key to confirm ~~ "Set Ok" pops up on the screen and rectums to the previous level; @.
i Tone Set If it Is allowed by CPS software, set and sack the prompt tones by accessing the Tone Set menu. Profiles Processes: 1. Access the menu, press [AW] key to chooses Tone Set, and then press [Select] key to enter. 2 Press [A/W] key to chooses Profiles and press [Select] key to enter. 3. Press [A/W] key to choose General or client, and press [Select] key to confirm the selection 4 "Profile Is set" pops up on the screen and rectums to the previous level, (D Key Tone Processes: 1.
2. Press | A/W] key to choose Gallstone and press [Select] Key to make following options and procedures: ©. Callow — press [Select] key —~ choose operation of Rx Begin Tone, Rx End Tone, Tx Begin Tons, Tx End Tons by [A/W] key — press [Sal act] key to tick or cancel It = press [Back] key to rectum to the previous level; @.
2. Press [A/W] key to choose GPS and press [Select] key to make following options and procedures: GPS switch — press [Select] key to um GPS Upload SW — press [Select] key — choose operation of RAGGA, GSA, GPGSV, GPRMC by [A/W] key — press [Select] key to dick or cancel — press [Back] key to rectum to the previous level; ®.
or seek the FM radio frequency automatically. 4. Press the [Back] key to exit the FM redo mode and rectum to the previous level. Or press [OK] key to make ths following options and procedures: $ave — press [Select] key to save the current FM radio channel; @. FM List — press [Select] key to display the list of saved FM radio frequencies — choose the desired frequency by — press [Select] key to Delete or Play the frequency @.
Headset Processes: 1. Access the menu, press [A/W] key to choose Appendix, and then press [Select] key to enter. 2. Press [A/W] key to choose Headset and press [Select] key to ante. 3. Choose operation of Spreadsheet, Loud Speaker, Headset by [A/W] key and press [Select] key to confirm 4. "Set OK" pops up on the screen and rectums to the previous level {i Note: < Headset is the choice of audio output mode of this radio.
#; Notes < The total recording time supported Is moral than 50 hours. It Is supported to purchase additional recording time according 1o the actual requirement. Wl Device Info If It Is allowed by CPS software, set and check Radio ID, Rx Group List, CH Contact (channel contact), Version and other Information by accessing Device Info menu. Processes: 1. Access the menu, press [A/W] key to choose Record, and then press [Select] key to enter. 2. Press [A/W] key to make following options and processes: @.
User-defined table Save VFO Save to specified channel For Scansion Made All available channels Notes © When accessing any sub menu, press the [Back] key to rectum to the previous level. © No matter in any sub menu or menu operation, press [ ] key to forcibly exit the operation and rectum to home screen for standby mods.
eT ET RET [11 Modes of TX and RX in scanning Set TX and RX call modes in scan list by CPS software. [0] Sean TX Mode In scanning, when there Is detected active channel or talk group, the radio will stay at the channel for a period of time, which Is called "idle time". © The scan TX modes of the scan list can be set as below: ® Talk back @.
Repeat Modes Samples Repeat Mode | Radio No. End wer 2 a Repeater | Band (Repeat) Remarks TX Frag: 446.050MHZ RX Frog: 446.050MHZ AB Digital fo Digital " Slot: 2; CC: 1 Sit 1 1.Time sits for RX/TX are with game settable based on needed; frequency * RX Freq: 446.050MHZ TX Freq: 446. 050MHZ AB But can't set same slot for Slot: 1; CC: 1 Slot 1; CC: 1 RXUTX I Ri with TX Freq: 446.050MHZ RX Freq: 446 050MHZ frequency. Slot; 2; CC: 1 Slot 2; CC: 1 2.
Digital to Analog Mode with same frequency: Radio No. End user 24 a Perpetrate 3% DR-S80V/x 5 Repeater Band (Repeat) Remarks Roquefort; 446.050MHZ| RX Freq: 448.050MHZ RX Frag: 144.050MHZ AB Slat: 1; CC: 1 Slot: 1; CC: 1 Slot: Freq: 448 050MHZ TX Freq: 446 050MHZ TX Freq: 144 050MH2Z a8 Slot: 2; CC: 1 Slot: 2; CC: 1 Slot: Freq: 144 050MHZ Analog Mode a# Analog ELIXIR Freq: Slot: 1; CC: 1 Analog TX Frag: ab a ote 448 050MHZ . TX Freq: 144.050MHZ 448.
Receive signal decreases, Is unclear or Is Interrupted. Malfunction Analysis of causes landing method Battery is installed incorrectly Re-Install battery Radio fails to power on Battery power power than preset value Please change or charge battery. Bad battery contacts or contacts In dirty. Check and clear the battery contacts. Battery power gets lows. Please change or charge battery. Volume control at low value. Adjust the volume to be higher. Antenna gets loose or antenna frequency is incorrect.
Malfunction Analysis of causes Handling method Weak vole traffic with knolls . . : curing communications Strong local environmental interference. Move away from interference source. Failure to obtain GPS position | Radio lacks optional GPS feature or satellite | Add GPS feature; move to open site with view blocked by environment. clear view of sky.
Maintenance and Clean To ensure the best performance and prolong working life, please acquaint yourself with the following for maintenance and cleaning. Maintenance © Please do not scratch or puncture the device with hard or sharp object. © Please do not place the device in an environment which can corrode electronic circuits or under direct solar radiation. © Please do not carry the device by Its antenna or headset. © Please make sure the SP-MIC plug Is covered when not in use.
Va Alr consult earphone Earphone-1 Earphone-2 Programmable cable Power supply for car charger Speaker microphone Multi-charger 57
The FCC waning Changes or modifications not expressly approved by the party responsible for compliance could cold the user's authority to operate the equipment. This device compiles with Part 15 of the FCC Rules. This device complies with Part 15 of the FCC Rules. Operation Is subject to the following two conditions: (1) This device may not cause harmful Interference (2) This device must accept any Interference received, Including Interference that may cause undesired operation.
information beaded to make him or her aware of RF exposure, and what to do to as-sure that this radii operates with the FCC RF exposures (Emits of this radio. Electromagnetic Interference/Compatlblilty During transmissions, The radio generates RF energy that can possibly causal Interference with other devices or systems.
