User's Manual

English:
Hardware Installation
1. Place two AA batteries in the keyboard as shown below.
2. Connect the dongle receiver to a USB port of a PC.
3. Turn on your computer.
Software Installation
No software is required to start up the wireless device.
Replace Batteries
If you feel that the wireless device does not respond when typing, check if the red LED is flashing when any key is
pressed. If not, this means that the batteries have lost their charge and need to be replaced.
Important: Do not mix or use different types of batteries at the same time.
ID Channel Setting
The channel ID is factory preset. The green LED (data transmission indicator of the receiver) will be lit constantly
when the wireless device is in normal operation. In case your wireless devices do not work, reset the ID channel
by:
1. Press the connect button on the receiver and the LED will be blinking for connection.
2. Press the connect button of the wireless device once within 20 seconds and observe if the LED light on the
receiver has gone off. If yes, it means the wireless device is ready for use.
Warning (Trouble shooting)
1. In case the wireless device was not connected when you set the ID channel setting, check if you have installed
the batteries with the positive (+) and negative (-) ends in the correct position, then repeat the ID channel
setting again.
2. For optimum performance, please make sure that the distance between the wireless device and the dongle
receiver does not exceed 10M.
Hot keys and functions:
Data transmission
indicator
Connect button