User's Manual

ENGLISH

Hardware Installation

1. You can connect the receiver to a PS/2 or USB port of a PC

2. Install two AA batteries in the mouse.

3. Turn on your computer. The mouse will now work.

4. After you open Windows, please press the button on the receiver first

and then press the button under the mouse for channel setting.

Important: Remember do not put the batteries in the wrong direction; use

the same types of batteries. Also, keep all drinks away! If any spill occurs

on the receiver, unplug the USB connector first and clean the receiver

immediately. Please switch the button to "off" under the mouse once you

don't use it for a long time, and remove the batteries if you do not use this

device for at least two weeks.

Warning: (Troubleshooting)

1. Please do not use the wireless optical mouse on a desk which is made

of glass, mirror, iron, or black velvet. Also, a flat surface is necessary

or the optical sensor will be error easily. When you use the wireless

optical mouse on a desk that is made of metal, try using a pad and

reduce the receiving distance.

2. Before the first installation is completed (channel setting ready), the

mouse will not work in DOS.

3. The wireless optical mouse channel provides 256 ID-codes, and it

automatically selects the ID # for your mouse. You can only set up

one wireless optical mouse at a time. But if you have additional

wireless optical mouse sets in an area of 10 square meters, more

interference will occur between the receiver and your mouse.

PAGE 1
ENGLISH Hardware Installation 1. 2. You can connect the receiver to a PS/2 or USB port of a PC Install two AA batteries in the mouse. 3. 4. Turn on your computer. The mouse will now work. After you open Windows, please press the button on the receiver first and then press the button under the mouse for channel setting. Important: Remember do not put the batteries in the wrong direction; use the same types of batteries.
PAGE 2
ENGLISH 4. 5. If you feel the mouse does not move smooth as usual, then the batteries have lost their charge and need to be replaced. Remember do not put the batteries in the wrong direction. The wireless optical mouse with radio frequency gives you free movement and an enjoyable experience. For optimal performance, place the receiver at least 8 inches (about 20cm) away from the mouse and other electrical devices, such as the computer, monitor and etc. Software Installation 1. 2. 3.
PAGE 3
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCCRules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.