User's Manual

ManualsBrandsKYE Systems ManualsComputers & AccessoriesGT-100006/ M MOUSE

ENGLISH

ENIUS

RAPHIC

ABLET

Q U I C K I N S TA L L AT I O N G U I D E

CAUTION: PLEASE

INSERT

THE

DRIVER

INTO

YOUR

COMPUTER

FIRST

AND

THEN

THE

INSTRUCTIONS

COMPLETE

YOUR

SETUP

PROCESS.

INTRODUCTION

DRIVER INSTALLATION

Windows:

1. Insert the driver disc into your computer’s CD-ROM drive. When prompted, select “Driver Setup”, and press OK to

install driver.

Note: In most systems, the Setup Wizard will start automatically. If Automatic Setup does not begin, start the Setup

program manually by selecting “Start/Run”, type "E:\setup", where “E:” represents the location of the CD-ROM

drive, then press “Enter”.

Note: In certain cases, Windows might ask for your permission because it cannot recognize the driver you are

downloading. If this occurs, select “Continue Anyway” and continue to install.

2. Please insert the driver CD into your computer first and then follow the instructions to complete your setup process.

Macintosh:

1. Insert the driver disc into your computer’s CD-ROM drive.

2. Check to see if the “Genius Tablet” is shown on the screen. Double click the icon then follow the instruction.

3. Enter your administrator name and password to process the next step till it’s finished.

Note: For more information, refer to the MAC user manual on the driver disc.

CAUTION: ONCE

THE

INSTALLATION

HAS

BEEN

COMPLETED,

REBOOT

YOUR

MACINTOSH

BEFORE

PLUGGING

THE

DEVICE

INTO

YOUR

COMPUTER.

HARDWARE INSTALLATION

CAUTION:

MAKE

SURE

THAT

YOU

HAVE

INSTALLED

THE

DRIVER

SOFTWARE

(SEE

ABOVE)

INTO

YOUR

COMPUTER

BEFORE

INSTALLING

THE

HARDWARE.

1. Plug the Graphic Tablet USB cable into your computer’s

USB port (located on the computer, display, or keyboard).

The Graphic Tablet’s LED light will indicate the operational

status, and your computer screen will display a “found new

hardware” message.

1. Working area

2. Button 2

3. Button 1

4. Pen tip

Summary of content (2 pages)

PAGE 1
ENGLISH G E N I U S G R AP H I C TA B LE T Q U I C K I N S TA L L AT I O N G U I D E CAUTION: PLEASE INSERT THE DRIVER CD INTO YOUR COMPUTER FIRST AND THEN FOLLOW THE INSTRUCTIONS TO COMPLETE YOUR SETUP PROCESS. INTRODUCTION 1. Working area 2. Button 2 3. Button 1 4. Pen tip DRI VER INSTALLATION Windows: 1. Insert the driver disc into your computer’s CD-ROM drive. When prompted, select “Driver Setup”, and press OK to install driver. Note: In most systems, the Setup Wizard will start automatically.
PAGE 2
ENGLISH VERIFYING THE INSTALLATION To ensure that everything has been installed properly, please follow the procedures below. Check the User’s manual on the CD-ROM for more information. V ERIFYING H ARDWARE AND D RIVER F UNCTIONS The LED light on the Tablet Plate is the main indicator for hardware operation. The light normally stays off, and will come on and off in response to various conditions. Watch the status of the Tablet Plate LED light as you go through these steps.