User's Manual

ManualsBrandsKYE Systems ManualsComputers & AccessoriesLaser Mouse

▼

Introduction

Congratulations on your purchase of a rocketfish 27MHz Wireless Laser Mouse. This

ergonomically designed mouse uses a radio frequency (RF) link that enables you to use

the mouse anywhere within distance of its receiver. No line-of-sight between the mouse

and its receiver is required. In addition to this user’s guide this package contains:

•

Mouse

•

USB receiver

•

2 AAA batteries

•

Carrying pouch

▼

System Requirements

Hardware

•

PC with a Pentium

processor or the equivalent

•

USB interface

Operating System

•

Windows

98SE/Me/2000/XP and Mac

▼

Connecting the Mouse Receiver

To connect the mouse receiver:

1. Plug the USB receiver into an available USB port on your computer.

2. Your computer’s operating system identies the receiver and begins installing the

default driver.

3. Follow any on-screen procedures to complete the default driver installation.

English

Summary of content (7 pages)

PAGE 1
English ▼ Introduction Congratulations on your purchase of a rocketfish 27MHz Wireless Laser Mouse. This ergonomically designed mouse uses a radio frequency (RF) link that enables you to use the mouse anywhere within distance of its receiver. No line-of-sight between the mouse and its receiver is required.
PAGE 2
English ▼ Using the mouse Install the batteries a. Press the battery releasing button to open battery cover. _ + _ + b. Insert batteries, making sure that the positive (+) and negative (-) ends of each battery match the polarity indicators inside the battery housing. c. Put on the battery cover.
PAGE 3
English ▼ Establishing a communications link The mouse has 256 identification codes that allow the mouse and its receiver to operate without interference from other radio frequency devices. After your computer detects the USB receiver and the driver is installed, you must establish a communications link between the mouse and its receiver BEFORE you can use the mouse. To do this, follow the instructions below: . Press and release the link button located on the receiver.
PAGE 4
English ▼ Operating hints For optimal performance and RF reception: • • • • • • Place the receiver at least 8 inches (20 cm) away from all electrical devices, such as your monitor, speakers or external storage devices. If necessary, use the extension cable to keep the receiver away from the computer. Plug the receiver into the extension cable, and the extension cable to the computer. Avoid using the mouse on a metal surface.
PAGE 5
English ▼ Specifications Laser Interface USB Low Speed Device HID Class Radio Frequency 27 MHz Working Distance More than 80 cm Working Principle Optical CMOS sensor CMOS Sensor Agilent ADNS-5030 Resolution Optical resolution1000 cpi Tracking Speed 14 ips Buttons 2 buttons plus roller button Wheel 1 scrolling wheel Power Switch Yes Battery 1.5V AAA size x 2 PCs Dimensions W 54.6mm x H 36mm x L 105mm Warranty 1 year Operating Voltage 1.
PAGE 6
English ▼ Troubleshooting What do I do if the mouse does not work? • • • • Make sure that the polarity of the batteries is correct. The positive (+) and negative (-) ends of each battery must match the positive (+) and negative (-) connections in the battery housing. Check that the receiver’s USB connector is firmly attached to the USB port on your computer. Verify that the device drivers are installed. Make sure you have established a radio link between the mouse and its receiver.
PAGE 7
English ▼ FCC statement United States Regulatory Information This device complies with part 5 of the FCC Rules. Operation is subject to the following two conditions: ( ) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. ▼ ICES-003 statement Canadian Regulatory Information This Class B digital apparatus complies with Canada ICES-003.