User's Manual

This document is the property of KYMATI GmbH and must not be copied or disclosed without its written authorisation.
© - KYMATI GmbH – 2020
KY.MAN.0105 (4.0) KY-LOC 1D.02.01 User Manual
Doc.- No.: KY.MAN.0105
Version: 4.0
Date: 17.05.2021
Page: 11 of 43
2.4 Compliance Statement USA
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
2.5 Compliance Statement Canada
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject
to the following two conditions:
(1) This device may not cause interference
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
Cet appareil contient des émetteurs / récepteurs exemptés de licence conformes aux RSS
(RSS) d'Innovation, Sciences et Développement économique Canada. Le fonctionnement est
soumis aux deux conditions suivantes:
(1) Cet appareil ne doit pas causer d'interférences
(2) Cet appareil doit accepter toutes les interférences, y compris celles susceptibles de
provoquer un fonctionnement indésirable de l'appareil.
2.6 Health and Safety Liability Statement
The ultimate responsibility for health and safety in connection with the installation and
operation of the KY-LOC 1D.02.01 system lies with the customer. The units comply with the
relevant regulations as stated in section 2.3. KY-LOC 1D.02.01 operators should ensure that
the health and safety regulations of the relevant country and site operations are met, and health
and safety instructions are followed.
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely
to cause harmful interference in which case the user will be required to correct the interference
at his own expense.
In order to comply with FCC and ISED RF Exposure requirements, this device
must be installed such that a minimum separation distance of 20cm is
maintained between the device and all persons during normal operation.