User's Manual

This document is the property of KYMATI GmbH and must not be copied or disclosed without its written authorisation.

KY.MAN.0105 (4.0) KY-LOC 1D.02.01 User Manual

Doc.- No.: KY.MAN.0105

Version: 4.0

Date: 17.05.2021

Page: 26 of 43

6 Setting Up the Devices and System Operation

This chapter describes how to operate the KY-LOC 1D.02.01 sensor. The following steps must

be taken to have a basic measurement running:

1. Install the devices (see chapter 6.1)

2. Power up the devices (see chapter 6.2)

3. Configure the communication links (see “Communication Setup” message in Chapter

4. Configure one device as Relay device (see chapter 7)

5. Connect to the device and run the system (see chapter 6.5)

6. Do the first measurement run (see chapter 6.6)

After this procedure, the system may be installed and will start automatically measuring if both

sensors are powered and synchronized.

6.1 Installation of the KY-LOC 1D.02.01 Sensor

For a proper operation, the following parts must be considered:

• The devices must face each other. For long range operation they should be aligned

better than 5 °.

• Minimum of 2 m distance between the two units must be maintained to guarantee the

specified accuracy.

• The orientation of the devices must be the same (please refer to chapter 3.2).

• The vertical and horizontal offset must be smaller than 0.5 m.