User's Manual

This document is the property of KYMATI GmbH and must not be copied or disclosed without its written authorisation.
© - KYMATI GmbH – 2020
KY.MAN.0105 (4.0) KY-LOC 1D.02.01 User Manual
Doc.- No.: KY.MAN.0105
Version: 4.0
Date: 17.05.2021
Page: 34 of 43
Destination IP
Address
Read /
Write
10
Unsigned
integer (32
bit)
IP address where all response
messages are sent to when
using the Ethernet connection.
Default: 192.168.75.01
= 0xC0 A8 4B 01
Destination IP
Port
Read /
Write
11
Unsigned
integer (32
bit)
Port where all response
messages are sent to when
using the Ethernet connection.
Default: 27513
Hardware
Revision ID
Read Only
12
Unsigned
integer (8
bit)
Revision of the PCB Board.
Microcontroller
Chip ID
Read Only
13
Byte Array
of Length
16
128 bit Identifier of the
Microcontroller
Radar Chip ID
Read Only
14
Byte Array
of Length
16
128 bit Identifier of the Radar
Chip
Microcontroller
Firmware
Version
Read Only
15
Byte Array
of Length
20
Radar
Firmware
Version
Read Only
16
Byte Array
of Length
20
Measurement Parameters (ParameterSet = Measurement)
Parameter
Parameter
Id
Datatype
Description
Relay/Remote
0
Unsigned Integer (8 bit)
0 = Relay
1 = Remote
Frequency Channel
1
Unsigned Integer (8 bit)
0-5
Frequency Band
2
Unsigned Integer (8 bit)
0-7
Reserved
3
Unsigned Integer (8 bit)
Reserved
4
Unsigned Integer (8 bit)
Reserved
5
Unsigned Integer (8 bit)
Firmware Update (ContentType = 0x0101)
This content is used to upload a given firmware image in the device’s non-volatile storage.
The entire firmware update process involves three phases: Exchange of firmware file size,
erasing flash sectors on the device and sending the actual firmware file content.
In the first phase, the host sends the file size to the device which then responds with an ACK
Status Message using the following content data frame: