User's Manual

This document is the property of KYMATI GmbH and must not be copied or disclosed without its written authorisation.
© - KYMATI GmbH – 2020
KY.MAN.0105 (4.0) KY-LOC 1D.02.01 User Manual
Doc.- No.: KY.MAN.0105
Version: 4.0
Date: 17.05.2021
Page: 41 of 43
10 Troubleshooting
Please contact the KYMATI Service Team if you cannot fix your problem with the given
instructions.
10.1 Diagnostic Information and LED Status
Figure 19: KY-LOC 1D.02.01 Physical Interfaces
Power LED (4)
If power is connected to the device this LED will illuminate. If this LED does not
illuminate check the power connection (see Section 5.2)
Status LED (5)
The status LED indicates the following operation modes:
Mode
Description
Off
Device is not powered
On
System ready
Upper (6), left (7), bottom (8), right (9) LEDs
These LEDs indicates the following operation modes:
Mode
Description
Off
Device is not powered
Blinking
Trying to synchronize
Constant Illumination
Radar provides range measurements, i.e. radars are synchronized
In future these LEDs may be used to support the installation.