User Guide

ManualsBrandsKymco ManualsOtherMO BW250

15. REAR BRAKE/REAR FORK/REAR

WHEEL/REAR SHOCK ABSORBER

15-0

Bet & Win 2 50

__________________________________________________________________________________

REAR BRAKE/REAR FORK/REAR WHEEL/

REAR SHOCK ABSORBER

__________________________________________________________________________________

SCHEMATIC DRAWING ---------------------------------------------- 15-1

SERVICE INFORMATION -------------------------------------------- 15-2

TROUBLESHOOTING ------------------------------------------------- 15-2

REAR BRAKE ----------------------------------------------------------- 15-3

REAR FORK ------------------------------------------------------------- 15-4

REAR WHEEL ---------------------------------------------------------- 15-4

REAR SHOCK ABSORBER-------------------------------------------- 15-5

Summary of content (7 pages)

PAGE 1
5.
PAGE 2
15.
PAGE 3
15. REAR BRAKE/REAR FORK/REAR WHEEL/REAR SHOCK ABSORBER Bet & Win 250 SERVICE INFORMATION GENERAL INSTRUCTIONS • When performing the services stated in this section, the engine and exhaust muffler must be cold to avoid scalding. • During servicing, keep oil or grease off the brake pads and brake disk. SPECIFICATIONS Item Rear wheel rim runout Rear shock absorber spring free length Rear brake disk thickness Rear brake disk runout Rear brake master cylinder I.D. Rear brake master cylinder piston O.D.
PAGE 4
15. REAR BRAKE/REAR FORK/REAR Bet & Win 250 WHEEL/REAR SHOCK ABSORBER Fluid Tube Bolt REAR BRAKE REAR BRAKE CALIPER REMOVAL First remove the exhaust muffler. (!2-6) Remove the rear brake fluid tube bolt and disconnect the brake fluid tube. Remove the two bolts attaching the rear brake caliper. Remove the rear brake caliper. ＊ When removing the brake fluid tube, use shop towels to cover plastic parts and coated surfaces to avoid damage.
PAGE 5
15. REAR BRAKE/REAR FORK/REAR Bet & Win 250 WHEEL/REAR SHOCK ABSORBER REAR FORK Shock Absorber Lower Mount Bolt REMOVAL Remove the exhaust muffler. (!2-6) Remove the rear brake caliper. (!15-3) Remove the right rear shock absorber lower mount bolt. Remove the rear axle nut and remove the collar. Remove the rear fork. The installation sequence is the reverse of removal. Turn the inner race of each bearing with your finger to see if they turn smoothly and quietly.
PAGE 6
15. REAR BRAKE/REAR FORK/REAR Bet & Win 250 WHEEL/REAR SHOCK ABSORBER Shock Absorber Lower Mount Bolt INSTALLATION The installation sequence is the reverse of removal. Torque: Rear shock absorber lower mount bolt: 19.6_ 29.4N-m Rear axle nut: 78.4_ 98N-m Brake Caliper Bolts ADJUSTABLE REAR CUSHION To suit scooter behaviour to load condition rear cushion could be adjusted in spring prelocad.
PAGE 7
15. REAR BRAKE/REAR FORK/REAR Bet & Win 250 WHEEL/REAR SHOCK ABSORBER Rubber Spring INSPECTION Inspect the damper rod for bending or damage. Inspect the damper for oil leaks. Inspect the damper rubber for deterioration or damage. Damper Rod Damper Measure the front shock absorber spring free length. Service Limit: Right : 226mm Left : 226mm ASSEMBLY Assemble the rear shock absorbers in the reverse order of disassembly. INSTALLATION Install the rear shock absorbers in the reverse order of removal.