User Guide

ManualsBrandsKymco ManualsOtherMO BW250

5. ENGINE REMOVAL/INSTALLATION

5-0

Bet & Win 2 50

__________________________________________________________________________________

ENGINE REMOVAL/INSTALLATION

__________________________________________________________________________________

SERVICE INFORMATION -------------------------------------------- 5-1

ENGINE REMOVAL --------------------------------------------------- 5-2

ENGINE INSTALLATION -------------------------------------------- 5-4

Summary of content (5 pages)

PAGE 1
5.
PAGE 2
5. ENGINE REMOVAL/INSTALLATION Bet & Win 250 SERVICE INFORMATION GENERAL INSTRUCTIONS • A floor jack or other adjustable support is required to support and maneuver the engine. Be careful not to damage the motorcycle body, cables and wires during engine removal. • Use shop towels to protect the motorcycle body during engine removal. • Drain the coolant before removing the engine. • After the engine is installed, fill the cooling system with coolant and be sure to bleed air from the water jacket.
PAGE 3
5. ENGINE REMOVAL/INSTALLATION ENGINE REMOVAL Bet & Win 250 Wire Connectors Disconnect the battery negative cable. Remove the frame body cover. (!2-3) Disconnect the engine negative cable. Disconnect all of the A.C. generator, auto bystarter, spark plug, thermosensor wire couplers and connectors. Disconnect the engine fuel tube. Drain the coolant. (!3-9) Disconnect the water hose. Rear Brake Caliper Disconnect the starter motor wire that goes to the starter relay.
PAGE 4
5. ENGINE REMOVAL/INSTALLATION Remove the right/left rear shock absorber upper mount bolts. Bet & Win 250 Rear Shock Absorber Upper Mount Bolts Remove the engine mounting bolt and pull out the engine. Engine Mounting Bolt ENGINE HANGER REMOVAL Remove the engine hanger bolts to remove the engine hanger. Bolt Engine Hanger Inspect the engine hanger bushings and stopper rubber for wear or damage.
PAGE 5
. ENGINE REMOVAL/INSTALLATION Bet & Win 250 ENGINE INSTALLATION Install the engine in the reverse order of removal. Tighten the engine mounting bolt. Torque: 49N-m Engine Mounting Bolt Tighten the rear shock absorber upper mount bolts. Torque: 39.2N-m After installation, inspect and adjust the following: • Throttle grip free play (!3-3) • Fill the rear brake reservoir with brake fluid and bleed air from the rear brake.