User Guide

ManualsBrandsKymco ManualsOtherMO BW250

2. EXHAUST MUFFLER/FRAME COVERS

2-0

Bet & Win 2 50

__________________________________________________________________________________

EXHAUST MUFFLER/FRAME COVERS

__________________________________________________________________________________

SCHEMATIC DRAWING ---------------------------------------------- 2-1

SERVICE INFORMATION -------------------------------------------- 2-2

TROUBLESHOOTING ------------------------------------------------- 2-2

FRAME COVERS REMOVAL----------------------------------------- 2-3

EXHAUST MUFFLER REMOVAL ----------------------------------- 2-6

Summary of content (7 pages)

PAGE 1
2.
PAGE 2
. EXHAUST MUFFLER/FRAME COVERS SCHEMATIC DRAWING 2-1 Bet & Win 250
PAGE 3
2. EXHAUST MUFFLER/FRAME COVERS Bet & Win 250 SERVICE INFORMATION GENERAL INSTRUCTIONS • When removing frame covers, use care not to pull them by force because the cover joint claws may be damaged. • Make sure to route cables and harnesses according to the Cable & Harness Routing. TORQUE VALUES Exhaust muffler lock bolt Exhaust muffler joint lock nut 34.3N-m 11.
PAGE 4
2. EXHAUST MUFFLER/FRAME COVERS Bet & Win 250 Bolts/Nuts FRAME COVERS REMOVAL REAR CARRIER & HAND RAIL REMOVAL Remove the met-in box: First remove the two bolts and two nuts attaching the met-in box. Remove the battery and fuse. Remove the met-in box. Fuse Hex Bolts Remove the hand rail right and left lock hex bolts. Remove the four hex bolts Remove the rear carrier and hand rail. Hex Bolts FRAME BODY COVER REMOVAL Remove the one screws on the bottom of the center cover. Remove the center cover.
PAGE 5
2. EXHAUST MUFFLER/FRAME COVERS Bet & Win 250 Remove the midst screw attaching the right and left side covers. Side Cover Screws Remove the screws attaching the right and left side covers. Screw Screws FLOOR BOARD REMOVAL Remove the floor mat. Remove the center cover. (!2-3) Remove the ten screws and four screws attaching the front right and left side covers. Remove the two bottom cover adjusting screws. Remove the front right and left side covers.
PAGE 6
2. EXHAUST MUFFLER/FRAME COVERS Bet & Win 250 FRONT UPPER COVER REMOVAL Remove the four screws on the back of the front upper cover. Remove the front upper cover. The installation sequence is the reverse of removal. Screws FRONT LOWER COVER REMOVAL First remove the front upper cover. Remove the two screws attaching the front lower cover. Remove the four screws on the back of the front lower cover. Disconnect the right/left turn signal light wire connectors.
PAGE 7
2. EXHAUST MUFFLER/FRAME COVERS Bet & Win 250 HANDLEBAR COVER REMOVAL First remove the seven screws attaching the handlebar back cover. Remove the handlebar back cover. Screws Bolts BOTTOM COVER REMOVAL Remove the side stand. Remove the four bolts attaching the bottom cover. Remove the bottom cover. Bottom Cover FRONT FENDER REMOVAL Remove the two bolts attaching the fender. Remove the front fender cover. The installation sequence is the reverse of removal.