User Guide

9. DRIVE AND DRIVEN PULLEYS/
KICK STARTER
9-11
Check the movable driven face for wear or
damage.
Measure the movable driven face I.D.
Service Limit: 34.06mm replace if over
DRIVEN PULLEY FACE BEARING
REPLACEMENT
Drive the inner needle bearing out of the
driven pulley face.
Remove the snap ring and drive the outer
bearing out of the driven face.
Apply grease to the outer bearing.
Drive a new outer bearing into the driven face
with the sealed end facing up.
Bearing Driver
Seat the snap ring in its groove.
Apply grease to the driven face bore areas.
Inner Bearing
Outer Bearing
Discard the removed bearing and replace
with a new one.
＊
Pack all bearing cavities with 9_ 9.5g
grease.
Specified grease: Heat resistance 230°C
＊
Discard the removed bearing and replace
with a new one.
＊
Special