User Guide

9. DRIVE AND DRIVEN PULLEYS/
KICK STARTER
9-14
Install the movable driven face onto the
driven face.
Apply grease to the guide rollers and guide
roller pins and then install them into the holes
of the driven face.
Install the seal collar.
Remove any excessive grease.
Set the driven pulley assembly, driven face
spring and clutch assembly onto the clutch
spring compressor.
Compress the clutch spring compressor and
install the drive plate nut.
Set the clutch spring compressor in a vise and
tighten the drive plate nut to the specified
torque.
Torque: 5.5kg-m
Clutch Spring Compressor
Outer Driver, 32x35mm
INSTALLATION
Install the clutch/driven pulley onto the drive
shaft.
Be sure to clean the driven face off any
grease.
＊
Align the flat surface of the driven face
with the flat on the clutch drive plate.
＊
Keep grease off the drive shaft.
＊
Movable Driven Face
Special
Guide Roller Pin
Guide Roller
Clutch/Driven Pulley
Driven Face
Clutch Spring Compressor
Lock Nut Wrench
Be sure to use a clutch spring
compressor to avoid spring damage.
＊