User Guide

ManualsBrandsKymco ManualsOtherMO MXer50

8. A.C. GENERATOR

8-0

MX’er 50

__________________________________________________________________________________

A.C. GENERATOR

__________________________________________________________________________________

SERVICE INFORMATION........................................................ 8-2

A.C. GENERATOR REMOVAL................................................. 8-3

A.C. GENERATOR INSTALLATION ........................................ 8-4

Summary of content (6 pages)

PAGE 1
8. A.C. GENERATOR MX’er 50 8 __________________________________________________________________________________ __________________________________________________________________________________ __________________________________________________________________________________ __________________________________________________________________________________ __________________________________________________________________________________ A.C.
PAGE 2
8. A.C. GENERATOR MX’er 50 Torque: 0.8_ 1.2kg-m Torque: 3.5_ 4.0kg-m Torque: 0.6_ 1.0kg-m Torque: 0.8_ 1.
PAGE 3
8. A.C. GENERATOR MX’er 50 SERVICE INFORMATION GENERAL INSTRUCTIONS • All A.C. generator maintenance and inspection can be made with the engine installed. • Refer to Section 14, 15 for A.C. generator inspection. TORQUE VALUE Flywheel nut : 3.5_ 4.
PAGE 4
8. A.C. GENERATOR MX’er 50 Fan Cover A.C. GENERATOR REMOVAL Remove the three bolts attaching the fan cover to remove the fan cover. Bolts Remove the cooling fan by removing the four bolts. Bolt Cooling Fan Nut Hold the flywheel with an universal holder and then remove the flywheel nut.
PAGE 5
8. A.C. GENERATOR MX’er 50 Remove the A.C. generator flywheel using the flywheel puller. Flywheel Puller A.C. Generator Wire Connector Remove the A.C. generator wire connector. Remove the two pulser coil bolts and pulser coil from the right crankcase. Remove the two bolts attaching the A.C. generator stator. Lock Nut Wrench Stator °ØBe careful not to damage the disconnected wire. A.C. GENERATOR INSTALLATION Install the A.C.
PAGE 6
8. A.C. GENERATOR Connect the A.C. generator wire connector. MX’er 50 A.C. Generator Wire Connector Woodruff Key Clean the taper hole in the flywheel off any burrs and dirt. Install the woodruff key in the crankshaft key way. Universal Holder Install the flywheel onto the crankshaft with the flywheel groove aligned with the crankshaft woodruff key. Hold the flywheel with the universal holder and install the 10mm flywheel flange nut. Torque: 3.5_ 4.0kg-m Start the engine and check the ignition timing.