User Guide

ManualsBrandsKymco ManualsOtherMO P50

7. A.C. GENERATOR

7-0

__________________________________________________________________________________

A.C. GENERATOR

__________________________________________________________________________________

SERVICE INFORMATION........................................................ 7-2

A.C. GENERATOR REMOVAL................................................. 7-3

A.C. GENERATOR INSTALLATION ........................................ 7-4

Summary of content (6 pages)

PAGE 1
7. A.C. GENERATOR 7 __________________________________________________________________________________ __________________________________________________________________________________ __________________________________________________________________________________ __________________________________________________________________________________ __________________________________________________________________________________ A.C.
PAGE 2
7. A.C. GENERATOR Torque: 0.8_ m Torque: 3.5_ m 7-1 1.2kg- 4.0kg- Torque: 0.6_ m 1.0kg- Torque: 0.8_ m 1.
PAGE 3
7. A.C. GENERATOR SERVICE INFORMATION GENERAL INSTRUCTIONS • All A.C. generator maintenance and inspection can be made with the engine installed. • Refer to Section 15 for A.C. generator inspection. TORQUE VALUE Flywheel nut : 3.5_ 4.
PAGE 4
7. A.C. GENERATOR A.C. GENERATOR REMOVAL Remove the three bolts attaching the fan cover to remove the fan cover. Fan Cover Remove the cooling fan by removing the four bolts. Bolts Bolt Cooling Fan Hold the flywheel with an universal holder and then remove the 10mm flywheel nut.
PAGE 5
7. A.C. GENERATOR Remove the A.C. generator flywheel using the flywheel puller. Lock Nut Wrench Flywheel Puller Remove the A.C. generator wire connector. A.C. Generator Wire Connector Remove the two pulser coil bolts and pulser coil from the right crankcase. Remove the pulser coil wire clamp from the right crankcase. Remove the two bolts attaching the A.C. generator stator. Stator Wire Clamp ＊ Be careful not to damage the disconnected wire. A.C. GENERATOR INSTALLATION Install the A.C.
PAGE 6
7. A.C. GENERATOR Connect the A.C. generator wire connector. A.C. Generator Wire Connector Clean the taper hole in the flywheel off any burrs and dirt. Install the woodruff key in the crankshaft keyway. Woodruff Key Install the flywheel onto the crankshaft with the flywheel groove aligned with the crankshaft woodruff key. Hold the flywheel with the universal holder and install the 10mm flywheel flange nut. Torque: 3.5_ 4.0kg-m Start the engine and check the ignition timing.