Operation Manual

17
CONTROLS & FEATURES
Instruments - Turnsignal indicators
The left turn signal indicator “ “ flashes when the left turn
signal is operated.
The right turn signal indicator “
“ flashes when the right turn
signal is operated.
Instruments - High beam indicator
The high beam indicator “ “ is illuminated when the high
beam is selected (using the switch on the left handlebar).
Instruments - Oil service indicator
The oil service indicator “ “ will illuminate during riding when
the engine oil service interval has been reached and the oil
should be serviced.
NOTE: When the ignition switch is turned “ON” the oil
service indicator will illuminate. The indicator should turn
off once the engine is running. If it does not turn off, take
your scooter to your KYMCO dealer for service.
To reset the oil service indicator, see the procedure on
pages 13 and 14 of this manual.
Instruments - Overheating indicator
The overheating indicator “ “ will illuminate during riding if
the coolant temperature exceeds the normal range. If the over-
heating indicator illuminates, stop the engine and check the
coolant reserve tank’s fluid level (see page 53).
NOTE: When the ignition switch is turned “ON” the over-
heating indicator will light for two seconds and then turn
off. This indicates the indicator is functioning normally.
The overheating indicator will illuminate if the engine
coolant temperature is too high. Do not operate the en-
gine unless the indicator goes out once the engine is
running.
Operating the scooter with the overheating indicator il-
luminated could result in damage to the engine. Con-
sult your KYMCO dealer for service if the overheating
indicator does not turn off during operation.