Operation Manual
34
Ignition cutoff feature
Your Yager 200i is equipped with a safety feature that will turn
off the ignition and the fuel pump to stop the engine if the scooter
is tipped over.
The angle detection sensor of this system must be reset once
the scooter is righted or the engine will not restart. Before re-
starting the engine, you must turn the ignition switch to the
“OFF” position and then back to “ON”. You can then start the
scooter normally.
OPERATION
Riding your scooter
NOTE: After starting, allow the engine oil to circulate be-
fore riding your scooter. Allow sufficient idling time after
warm or cold engine start-up before applying load or rev-
ving the engine. This allows time for the lubricating oil to
reach all the critical engine components.
NOTE: Review the scooter safety recommendations on
pages 3 and 4 before you ride.
Make sure flammable materials such as dry grass or
leaves do not come in contact with the exhaust system
when riding, idling, or parking your scooter
.
1. Make sure the throttle is closed and the rear brake brake is
engaged before moving the scooter off the main stand.
2. Mount the scooter from the left side and sit on the seat
upright. Place both hands on the handlebars and touch the
ground with your left foot for stability.