User's Manual

5-8 Troubleshooting
Maintenance Indication
The table below shows the indicator combinations when user
intervention is required. It is assumed that the printer is online and is
processing data.
Indicator Meaning Remedy
There is no paper in the cassette
or MP tray. The empty paper
source and required paper size
are shown in Status Monitor and
COMMAND CENTER.
Load paper into the paper source.
The cassette is not inserted
properly.
Insert the cassette fully into the printer.
The front cover is open. Close the cover.
There is no cassette in the paper
feeder or the cassette is not
inserted properly.
Re-insert the cassette and then try
printing again.
The cassette does not contain the
paper specified by the printer
driver.
Load the size and type of paper shown
in Status Monitor and COMMAND
CENTER into the cassette (#[1 or 2])
and then restart printing. You can
change the paper source by pressing
the [GO].
The paper sizes do not match. If the paper size in the paper source
differs from the paper size and type
specified by the printer driver, you can
print by supplying paper from the MP
tray. Load the correct paper size and
type into the MP tray and press [GO] to
begin printing.
If you want to supply paper from a
source other than the MP tray, you can
change the paper source by pressing
[GO].
If the paper fed from the MP tray is a
different size from the specified paper
size, a paper jam will occur.
A paper jam occurred during
printing.
Open the printer cover and remove the
jammed paper.