Specifications

9-14
Troubleshooting > Troubleshooting
R
S
T
U
Error Message Checkpoints Corrective Actions
Reference
Page
Remove original from
document processor.
Are there any originals left in the
document processor?
Remove originals from the document
processor.
—
Replace all originals and
press Start key.
― Remove originals from the document
processor, put them back in their original
order, and place them again. Press
[Cancel] to cancel the job.
—
Restricted by Job
Accounting. Job is canceled.
― This job is canceled because it is
restricted by Job Accounting. Press the
[OK] key.
—
Error Message Checkpoints Corrective Actions
Reference
Page
Scanner memory is full. Job
is canceled.
― Scanning cannot be performed any
more due to insufficient memory of
scanner. The job is canceled. Press the
[OK] key.
—
Shake the toner container. ― Open the front cover of the machine and
pull out the toner container. Shake the
toner container well and reinstall it.
page 9-3
Error Message Checkpoints Corrective Actions
Reference
Page
The slit glass requires
cleaning.
― Clean the slit glass using the cleaning
cloth supplied with the document
processor.
page 9-2
Tone r is l o w.
(Replace when empty.)
― It is almost time to replace the toner
container. Obtain a new toner container.
—
Error Message Checkpoints Corrective Actions
Reference
Page
Unknown Toner Installed. PC Does the installed toner container's
regional specification match the
machine's?
Install the specified toner container. —
USB cable was
disconnected.
Is the USB cable connected? Press the [OK] key and connect the
USB cable.
page 2-7
Is the PC powered on? Press the [OK] key and turn the PC
power on.
—
Cannot find KYOCERA Client Tool. Press the [OK] key and open
KYOCERA Client Tool.
page 7-22