User's Manual
Table Of Contents
- Introduction
- FCC statement
- Interface connectors
- Safety information
- IMPORTANT SAFEGUARDS
- Declaration of Conformity (U.S.A.)
- CE Marking Directive
- Declaration of Conformity (Australia)
- Canadian Department of Communications compliance statement
- ISO 7779
- Disclaimer
- Prolonged Non-Use and Moving the Printer
- ENERGY STAR
- The action program Energy 2000
- Kyocera ECO-PRODUCT
- Introduction
- Table of Contents
- Chapter 1 Installing the Printer
- 1.1. Positioning the Printer
- 1.2. Unpacking and Inspection
- 1.3. Names of Parts
- 1.4. Setting Up and Interfacing
- 1-Open the top cover
- 2-Install the toner container
- 3-Close the top cover
- 4-Install the waste toner bottle
- 5-Adjusting the paper guides in the cassette and adding paper
- 6-Open the paper stopper on the face-down output tray
- 7-Install the face-up output tray (if required)
- 8-Connect the printer to the computer
- 9-Attach the power cord
- 10-Print a status page
- 11-Test the interface with the computer
- 12-Set the emulation mode
- 13-Install the printer driver
- 1.5. MP (Multi-Purpose) Tray Feeding
- 1.6. Memory Card
- 1.7. Memory Expansion Installation
- Chapter 2 Operating the Laser Printer
- 2.1. Control Panel
- 2.2. Operating Procedures
- 2.3. Using the Mode Select Menu
- 2.4. Configuring Interfaces
- 2.5. RAM DISK
- 2.6. Operating a Memory Card
- 2.7. Setting Custom Sizes
- 2.8. Setting the Paper Type
- 2.9. Sleep (Ecopower) Mode
- 2.10. Dumping Received Data
- 2.11. KIR 2 Level
- 2.12. Ecoprint Mode
- 2.13. Resource Protection
- 2.14. Adjusting the Print Density
- 2.15. Setting the Audio Warning (Buzzer)
- Chapter 3 Fonts
- Chapter 4 Maintenance
- Chapter 5 Troubleshooting
- Appendix A Printer Specifications
- Appendix B Paper Selection
- Appendix C Host Computer Interface
- Index
- Mode Select Menu
1.5. MP (Multi-Purpose) Tray Feeding
1-21
Cassette Mode
1. Press the MODE key to display 3DSHUýKDQGOLQJýýý!.
2. Press the (Form Feed) key to display !03ýWUD\ýPRGH.
3. After pressing the ENTER key, the mode display is changed by pressing the + and – keys. Display
&DVVHWWH and then press the ENTER key.
!03 WUD\ PRGH
&DVVHWWH
4.
Press the EXIT key.
5. Insert the paper so that it is aligned straight in the
tray. About 100 sheets (0.1 mm thickness) can be
inserted at one time.
5HDG\ appears on the message display.
6. Carefully lower the protector bar, and the paper will be correctly set in the MP tray.
Feeding Envelopes
Envelopes should be fed face up, right side first, as shown below. From the MODE SELECT menu, set the
printer to print in landscape page orientation.
☛ To avoid trouble, we recommend that envelopes
are delivered face-up. Use the STACK key on the
printer control panel to select the face-up tray.
Not all envelopes print well. See Appendix B for details
on suitable types of envelopes.
See page 2-3 for the envelope sizes that can be set.
Protector Bar
Envelope