User's Manual
Table Of Contents
- Introduction
- FCC statement
- Interface connectors
- Safety information
- IMPORTANT SAFEGUARDS
- Declaration of Conformity (U.S.A.)
- CE Marking Directive
- Declaration of Conformity (Australia)
- Canadian Department of Communications compliance statement
- ISO 7779
- Disclaimer
- Prolonged Non-Use and Moving the Printer
- ENERGY STAR
- The action program Energy 2000
- Kyocera ECO-PRODUCT
- Introduction
- Table of Contents
- Chapter 1 Installing the Printer
- 1.1. Positioning the Printer
- 1.2. Unpacking and Inspection
- 1.3. Names of Parts
- 1.4. Setting Up and Interfacing
- 1-Open the top cover
- 2-Install the toner container
- 3-Close the top cover
- 4-Install the waste toner bottle
- 5-Adjusting the paper guides in the cassette and adding paper
- 6-Open the paper stopper on the face-down output tray
- 7-Install the face-up output tray (if required)
- 8-Connect the printer to the computer
- 9-Attach the power cord
- 10-Print a status page
- 11-Test the interface with the computer
- 12-Set the emulation mode
- 13-Install the printer driver
- 1.5. MP (Multi-Purpose) Tray Feeding
- 1.6. Memory Card
- 1.7. Memory Expansion Installation
- Chapter 2 Operating the Laser Printer
- 2.1. Control Panel
- 2.2. Operating Procedures
- 2.3. Using the Mode Select Menu
- 2.4. Configuring Interfaces
- 2.5. RAM DISK
- 2.6. Operating a Memory Card
- 2.7. Setting Custom Sizes
- 2.8. Setting the Paper Type
- 2.9. Sleep (Ecopower) Mode
- 2.10. Dumping Received Data
- 2.11. KIR 2 Level
- 2.12. Ecoprint Mode
- 2.13. Resource Protection
- 2.14. Adjusting the Print Density
- 2.15. Setting the Audio Warning (Buzzer)
- Chapter 3 Fonts
- Chapter 4 Maintenance
- Chapter 5 Troubleshooting
- Appendix A Printer Specifications
- Appendix B Paper Selection
- Appendix C Host Computer Interface
- Index
- Mode Select Menu
4.1. Toner Kit Replacement
4-3
6. Install the toner container on the developer as shown
in the diagram.
☛ Be sure to peel off the seal on the toner container
before mounting the toner container on the devel-
oper unit.
7. When the toner container is installed correctly on
the developer.
8. Push the top of the toner container unit ("PUSH HERE")
until it locks in.
☛ Make sure that the toner container is properly
locked in the printer.
9. Close the top cover by pressing the arrowed part in
this diagram.
☛ It is necessary to clean the inside of the printer
after replacing the toner container.
If the toner container is replaced when the messageý5HSODFH 7RQHUý&OHDQ SULQWHU is dis-
played, the messageý&OHDQýSULQWHUý3UHVVý&217,18( will be displayed after replacement.
After cleaning the inside of the printer (See Section 4.2. Cleaning), the message will disappear when
the CONTINUE key is pressed, and the printer will be ready for printing.