User manual

Chapter 1 Introducing the Kyocera 7135 Smartphone 3
Turning the phone on and off
4. Slide the base of the phone into the sync cradle.
The message “Phone is charging” appears on the screen.
Before your first use of the phone, wait until the message
“Charging is complete” appears. If the battery is completely
drained, it may take 2-3 hours to charge the first time.
Once the main battery is charged, you can use the Kyocera
7135 Smartphone in or out the cradle for all functions.
Leaving the phone in the cradle when not being used is a
convenient way to keep the battery charged.
5. If you purchased an extra battery, it can be recharged in the cradle at the same time. Slide the
battery into the rear port with the Kyocera label facing up.
The light on the sync cradle shows the battery’s status in the rear port.
■ No light—No battery installed.
■ Red—Battery charging.
■ Green—Battery fully charged.
■ Slow flashing red—Battery is not making contact or there is a charging problem. Reset the
battery. If the problem is not resolved, contact your service provider.
■ Fast flashing red—An incorrect charging accessory is being used to charge the battery. Use
only the Kyocera 7135 sync cradle or the correct power cable.
Note: The first port filled is the first port charged. If you insert an extra battery into the rear port before
placing the phone in the front port, the extra battery is charged first.
Turning the phone on and off
To turn on the phone for the first time
1. Flip the phone open and press and hold for a few seconds. You see the message
“Powering on”.
2. Remove the stylus from its slot on the top left side of the phone.
3. Follow the procedures in the welcome screens to calibrate the phone. Use the stylus to tap the
screen when instructed.