User manual
Table Of Contents
- Introducing the Kyocera 7135 Smartphone
- Making and Receiving Calls
- Dialing calls on the keypad
- Making a call from Speed Dial
- Making a call from the Address Book
- Redialing recent calls
- Checking your own phone number
- Making a data connection
- Answering calls
- Answering calls “hands-free”
- Ending calls
- Adjusting sounds
- Seaching for contacts
- Using power-save mode
- Viewing the phone status bar
- Using the Organizer
- Transferring Information
- Installing Palm Desktop for the 7135 Smartphone
- Synchronizing data using the sync cradle
- Synchronizing data remotely
- Synchronizing data using the infrared port
- Creating a user profile
- Modifying synchronization options
- Customizing a conduit
- Transferring information between Palm devices
- Troubleshooting HotSync operations
- Beaming information
- Address Book
- Call History and the Recent Calls List
- Date Book
- Memos
- Messages
- Setting Up Network Connections
- Speed Dial
- Setting Phone Preferences
- About preferences
- Setting Accessory preferences
- Setting Dialing preferences
- Setting Display preferences
- Setting Flip preferences
- Setting Incoming Call preferences
- Setting Keypad preferences
- Setting Phone Alert preferences
- Setting Phone Service preferences
- Setting Power preferences
- Setting Security preferences
- Setting Voice Dialing preferences
- Setting PDA Preferences
- To Do List
- Voice Dial
- Troubleshooting
- Glossary
- End-User Software License Agreement
190 Kyocera 7135 Smartphone Reference Guide
Troubleshooting tips
The calibration screen appears.
Note: If the calibration screen does not appear, the hard reset was not accomplished. Go back to step 1 and
try again.
6. Follow the instructions to calibrate the screen. When calibration is complete, the smartphone
is ready to use.
7. Run a HotSync operation to restore the data on your computer to the smartphone.
Troubleshooting tips
HotSync operations
The HotSync operation fails to start.
❑ Make sure your computer is turned on, and that it does not shut down automatically as part
of an energy-saving feature.
❑ Check the cable between the cradle and the computer serial port.
❑ Make sure you selected the correct serial port on the Local tab in the Setup dialog. Select the
port where you connected the cradle.
❑ Make sure you are not running another program—such as America Online, CompuServe or
WinFax—that uses the same serial port.
❑ Verify that HotSync Manager is running. If it
is running, exit and restart it.
❑ Make sure you selected Local from the HotSync Manager menu or the Kyocera 7135
smartphone Desktop menu.
The HotSync operation does not run to completion.
❑ Do not turn the phone on or off during a HotSync operation.
❑ If you have problems using the As Fast As Possible option or a specific speed, select a lower
baud rate setting on the Local tab in the Setup dialog.
❑ Read the HotSync Log for the user account for which you are synchronizing the phone and
computer. The HotSync Log may indicate where the problem is occurring.
General troubleshooting
The phone does not turn on.
❑ Adjust the contrast control.
❑ Make sure the battery is installed properly.
❑ Charge the battery for about 15 minutes.
❑ Replace the battery. If the phone still does not operate, try a soft reset. (See “Resetting the
phone” on page 189.)