User manual

48 Kyocera 7135 Smartphone Reference Guide
Synchronizing data using the sync cradle
Synchronizing data using the sync cradle
Running your first synchronization
The first time you synchronize data, you must enter user information on both the phone and the
Palm Desktop for the 7135 Smartphone.
Important considerations
■ You must perform your first synchronization with a local, direct connection using the sync
cradle, rather than using a modem or the infrared port. After the first synchronization, you
can use the other methods explained in this chapter.
■ Do not turn the phone power on or off during synchronization.
■ Do not remove the phone from the sync cradle during synchronization.
■ If you are a Palm user, read “Transferring information between Palm devices” on page 63
before you synchronize the phone.
■ If you are a System Administrator preparing several phones for a group of users,
see “Synchronizing data using the infrared port” on page 54 before performing the
following steps.
To synchronize data the first time
1. Once you have installed the Desktop, click the icon in
the Windows system tray.
If the icon does not appear in the system tray, open the
Start menu and select
Programs > Palm Desktop for the
7135 Smartphone
> HotSync Manager.
2. In the popup menu, verify that either Local Serial or Local
USB
is checked.
3. Click Setup. The Setup window appears.
4. Click the Local tab.
5. In the Serial Port field, select the port where you connected the cable. Click OK.
Note: USB users do not need to specify a serial port.
Make sure there is a
check mark beside
Local.
Then click Setup.