User manual
Table Of Contents
- Introducing the Kyocera 7135 Smartphone
- Making and Receiving Calls
- Dialing calls on the keypad
- Making a call from Speed Dial
- Making a call from the Address Book
- Redialing recent calls
- Checking your own phone number
- Making a data connection
- Answering calls
- Answering calls “hands-free”
- Ending calls
- Adjusting sounds
- Seaching for contacts
- Using power-save mode
- Viewing the phone status bar
- Using the Organizer
- Transferring Information
- Installing Palm Desktop for the 7135 Smartphone
- Synchronizing data using the sync cradle
- Synchronizing data remotely
- Synchronizing data using the infrared port
- Creating a user profile
- Modifying synchronization options
- Customizing a conduit
- Transferring information between Palm devices
- Troubleshooting HotSync operations
- Beaming information
- Address Book
- Call History and the Recent Calls List
- Date Book
- Memos
- Messages
- Setting Up Network Connections
- Speed Dial
- Setting Phone Preferences
- About preferences
- Setting Accessory preferences
- Setting Dialing preferences
- Setting Display preferences
- Setting Flip preferences
- Setting Incoming Call preferences
- Setting Keypad preferences
- Setting Phone Alert preferences
- Setting Phone Service preferences
- Setting Power preferences
- Setting Security preferences
- Setting Voice Dialing preferences
- Setting PDA Preferences
- To Do List
- Voice Dial
- Troubleshooting
- Glossary
- End-User Software License Agreement
56 Kyocera 7135 Smartphone Reference Guide
Synchronizing data using the infrared port
8. Accept the defaults provided by the Add Infrared Device Wizard, except when the Wizard
asks you to select the port to which your infrared device is connected. Be sure that an
available communications port is selected. Do not select the port that the HotSync Manager
currently uses.
9. If an alert appears telling you that there is a communication port conflict, click OK and
proceed with the rest of the installation using the defaults provided.
To configure HotSync Manager for infrared communication
When your computer is prepared for infrared synchronization, you must specify the simulated
port to be used.
1. Click in the Windows system tray to open the menu.
2. Make sure that Local is checked on the menu. Then click Setup.
3. Click the Local tab.
4. In the Serial Port drop-down box, select the COM port that was given as the simulated port in
the Options tab of the Infrared Monitor (in this example, COM4).
5. Click OK.
The HotSync Manager is now communicating with the simulated port defined for infrared
communication. This means you cannot use your cradle again until you reconfigure the
HotSync Manager to communicate with the port defined for cradle synchronization.
To synchronize data using the infrared port
1. Tap to view the applications screen.
2. Tap to select HotSync.
3. If Local is not already selected, tap Local.
4. Tap the below the icon and select IR to a PC/Handheld.
5. Position the infrared port of your phone within a few inches of the infrared port of
your computer.
6. Tap the HotSync icon to start the synchronization.
May be either on or off