User manual

Default Setting (System Menu)
9-104
LAN Interface
Specify the settings for the LAN interface to be used. The default setting is Auto.
IMPORTANT: After changing the setting, restart the network from the system menu, or turn the machine OFF
and then ON. For detailed information on restarting the network, refer to Restart Network on page 9-104.
Use the procedure below.
1 Press the System Menu key.
2 Press [System], [Next] of Network and then [Change] of LAN Interface.
3 Select [Auto], [10BASE-T Half], [10BASE-T Full], [100BASE-TX Half], [100BASE-TX Full] or [1000BASE-
T] as the LAN interface.
4 Press [OK].
Restart Network
To restart the network card of the device, follow the steps below.
1 Press the System Menu key.
2 Press [System], [Next] of Network and then [Start] of Restart Network.