- MITA AMERICA, INC. Operation Guide FAX SYSTEM

Section 6 Various Settings and Registration
6-3
(Inch)
(Metric)
(Inch)
(Metric)
(Inch)
(Metric)
Setting the Number of Rings
(Auto Fax Reception)
The number of times the fax will “ring” before an incoming call is
answered in the Auto Fax Reception mode, the Auto FAX/TEL
Switching mode [this setting is not available in metric models] or the
TAD Reception mode can be set here to any number between 1 and
15.
* If you want to cancel the procedure part way through, press the
Reset key. The touch panel will return to the initial mode settings.
1. Press the Default key. The Default Setting screen will appear.
2. Touch the “Fax default” key.
3. Touch the “▼” key until “# of Rings” is highlighted.
4. Touch the “Change #” key.
5. Use the “+” or “-” key to select the number of “rings” before an
incoming call is answered in each mode: the Auto Fax Reception
mode, the Auto FAX/TEL Switching mode [this setting is not
available in metric models] and the TAD Reception mode.
6. Touch the “Close” key. If you are finished making settings, press
the Reset key.
Making Volume Settings
The volume of the alarm, the monitor and the speaker can be
adjusted here, or you can make the alarm inaudible.
<Alarm Volume>
Sets the volume of the alarm that sounds in the event of an error
or when you press an incorrect key on the operation panel.
<Monitor Volume>
Sets the volume of the internal speaker that allows you to listen
to conditions on the telephone line when the “On-hook” key was
NOT touched.
<Speaker Volume>
Sets the volume of the internal speaker that allows you to listen
to conditions on the telephone line when the “On-hook” key WAS
touched.
* If you want to cancel the procedure part way through, press the
Reset key. The touch panel will return to the initial mode settings.
1. Press the Default key. The Default Setting screen will appear.
2. Touch the “Fax default” key.
3. Touch the “▼” cursor key until “Set Volume” [“Set the sound
volume”] is highlighted.