- MITA AMERICA, INC. Operation Guide FAX SYSTEM

Section 6 Various Settings and Registration
6-9
(Inch)
(Metric)
(Inch)
(Metric)
(Inch)
(Metric)
(Inch)
(Metric)
Turning 2 in 1 Reception ON/OFF
If 2 in 1 reception is turned ON and two 5 1/2" x 8 1/2" [A5] size pages
are received in a row during the same reception, those 2 pages will
be printed onto a single sheet of 11" x 8 1/2" [A4R] size paper. In
order to accomplish 2 in 1 Reception, it is necessary to turn this
function ON here in advance.
* 2 in 1 Reception will not be available when both 2 in 1 Reception
and Duplex Reception are turned ON.
* If you want to cancel the procedure part way through, press the
Reset key. The touch panel will return to the initial mode settings.
1. Press the Default key. The Default Setting screen will appear.
2. Touch the “Fax default” key.
3. Touch the “▼” cursor key until “2 in 1 RX” is highlighted.
4. Touch the “Change #” key.
5. Select whether you want to turn 2 in 1 Reception ON or OFF by
touching either the “On” or “Off” key, as appropriate.
6. Touch the “Close” key. If you are finished making settings, press
the Reset key.
Turning Remote Diagnosis ON/OFF
Especially if trouble occurs in this fax in which it is necessary to call
for service, it is possible for our service center computer to access the
fax directly over the telephone line and check its status and other
information about the trouble.
* To use Remote Diagnosis, it is necessary to enter into a contract
with an authorized service center in advance and also to register a
predetermined Remote Test ID in advance. (Refer to "Registering
the Remote test ID" on page 6-10.) For further information, contact
your service representative, an authorized service center or the
place of purchase.
* If you want to cancel the procedure part way through, press the
Reset key. The touch panel will return to the initial mode settings.
1. Press the Default key. The Default Setting screen will appear.
2. Touch the “Fax default” key.
3. Touch the “▼” cursor key until “Remote Diag.” [“Remote diagn.”] is
highlighted.
4. Touch the “Change #” key.
5. Select whether you want to turn Remote Diagnosis ON or OFF by
touching either the “On” or “Off” key, as appropriate.
6. Touch the “Close” key. If you are finished making settings, press
the Reset key.