- MITA AMERICA, INC. Operation Guide FAX SYSTEM

4-13

Section 4 Other Features of this Fax

(4) Printing Out Documents from an F-Code

Confidential Box

Perform the following procedure to print out documents that have

been received into your F-Code Confidential Box. If the documents

are printed out correctly, the data will be deleted from that box.

If you are using an F-Code Confidential Box for F-Code Based

Bulletin Board Transmission and you want to delete that data, simply

print the documents out and the data will be deleted from that box.

* If you registered “0000” as the F-Code password for your F-Code

Confidential Box, it is not necessary to enter a password just to print

out documents from that box.

* If you want to cancel the procedure part way through, press the

Reset key. The touch panel will return to the initial mode settings.

(Inch)

(Metric)

(Inch)

(Metric)

5. Use the keypad to enter the appropriate subaddress.

* This subaddress is required during an F-Code Based

Communication in order to designate the box in the destination

party's fax. It can be up to 20 digits in length and can include any

combination of the numerals 0 - 9 and the symbols “*” and “#”.

* You can use the “r” and/or “R” keys to move the cursor to a

desired location, and you can clear the entered number by

touching the “Delete” key.

6. Touch the “Password” key.

7. If necessary, use the keypad to enter the predetermined F-Code

password.

* The password can be up to 20 digits in length and can include

any combination of the numerals 0 - 9 and the symbols “*” and

“#”.

* This password is not required if you agree in advance with the

destination party not to use one.

8. Touch the “Close” key.

The message display will return to the same screen as was

displayed in step 2. You can now change any transmission settings

that you want or set the time for the transmission to begin.

9. Press the Start key. The transmission operation will begin.

1. Touch the “Application” key. The Application screen will appear.

2. Touch the “Print data in box” [“Sub.conf. box output”] key.