Installation guide

9-10
Troubleshooting
Remove original in
document
processor.
Error has occurred An original remains in the
document processor.
Remove originals from the
document processor, put them
back in their original order, and
place them again. Press [OK]
to resume printing. Press
[Stop/Reset] to cancel the job.
Remove the paper
from the inner
tray.
Inner tray full The inner tray is full of
paper.
The machine pauses after 100
sheets are printed. Remove
paper from the inner tray and
press [OK] to resume printing.
Replace MK. Replacing the
Maintenance Kit
Replacement of the
maintenance kit is
necessary at every 100,000
images of printing.
Replace Maintenance Kit.
Scanner memory is
full.
Memory full Scanning cannot be
performed due to insufficient
memory of scanner.
Only the scanned pages are
available. Press [OK] and the
job will be canceled.
Scheduled sending
jobs exceeded.
Error has occurred The number of the
scheduled transmission jobs
has exceeded the limit.
Wait until the scheduled
transmission is executed, or
cancel the scheduled
transmission and then perform
the job again.
Set paper in MF
tray and press OK
key.
Add paper Paper is not set in the
Manual Feed tray.
Load paper into the Manual
Feed tray and press [OK] to
begin printing.
Toner is running
out.
Toner is running out. It is almost time to replace
the toner container.
Obtain a new toner container.
Unknown toner
installed.PC
Error has occurred The installed toner
container's regional
specification does not match
the machine’s.
Install the specified toner
container.
USB cable was
disconnected.
— The USB cable is not
connected.
Press [OK] and connect the
USB cable.
The PC is powered off. Press [OK] and turn the PC
power on.
Cannot find KYOCERA
Client Tool.
Press [OK] and open
KYOCERA Client Tool.
— Not connected. The USB cable is not
connected.
Connect the USB cable.
The network cable is not
connected.
Connect the network cable.
The machine is powered off. Turn the machine power on.
Cannot find the appropriate
driver.
Install the appropriate driver.
Message Display
Message displayed in
KYOCERA Client Tool and
Status Monitor*
Meaning Remedy