Installation guide

2-22
Preparation
If the installer does not detect a print system, check that the print system is connected via
USB or a network and that it is turned on. Then click (Refresh) to search print system
again.
2 Select the machine you want to install, select the Driver Package, and click Install.
3 A message appears saying that your software is ready to use. To print a test page, select
the Print a test page checkbox and select the machine.
Click Finish to exit the installation wizard.
This completes the software installation procedure.
Custom Install
Use Custom Install if you want to specify the printer port and select the software to be installed.
1 Select Custom Install tab.
2 Select the device to be installed, and click the arrow button to move it to the Products to
Install list.
3 Select the software to be installed, and click the arrow button to move it to the Products to
Install list.
4 Click Install.
5 A message appears saying that your software is ready to use. To print a test page, select
the Print a test page checkbox and select the machine.
Click Finish to exit the installation wizard.
This completes the software installation procedure.
Note While the information shown in Windows 7 and Windows Vista/Windows XP
installation dialog boxes differs slightly, the installation procedure is the same.
Network connection is only possible with the FS-1025MFP, FS-1125MFP and
FS-1325MFP.
Note If the Found New Hardware Wizard appears, click Cancel. If a hardware
installation warning message appears, click Continue.
If the Windows security window appears, click Install this driver software anyway.