System information

COMMAND CENTER Pages
Operation Guide 13
Basic > Security > Device Security > Interface Block
This page allows you to restrict access from each interface.
Basic > Security > Device Security > Network Security
This allows you to enable communication with the printing system on a per-protocol
basis.
Basic > Security > User Login
When the authentication function is set on the Advanced > Management >
Authentication page (Local Authentication, depending on model), you must register
users and set access levels on this page.The available access levels are User and
Administrator.
One administrator account is registered by default.
Adding a New User Login
1. Open the User Login page.
2. Click Add and enter the information of the user.
3. Click Submit.
Item Description
Network
Specifies whether or not to restrict access from each of the
interfaces on the left. Access from the interfaces that are set
to Block is restricted.
Access from the network interface cannot be restricted.
Access can be restricted on a per-protocol basis. Refer to the
next section.
USB Device
USB Host
Parallel I/F
Optional I/F
Item Description
SNMP v3,
NetWare,
AppleTalk,
NetBEUI, Raw,
IPP, IPP over
SSL, HTTP,
HTTPS, FTP
(Transmission),
FTP
(Reception),
SMB, SNMP,
SMTP, POP3,
LPD, LDAP,
WSD Print,
WSD Scan
Specifies whether or not to restrict communication via each
of the protocols on the left.
The communication via the protocols that are set to Lock is
restricted.
The settings made on this page affect the protocol settings
on the Advanced page.