System information

COMMAND CENTER Pages
38 KYOCERA COMMAND CENTER
Each logical printer can be used with either the FTP, LPR, IPP, NetBEUI, or Raw Port
protocol. All printout to a non-existent port will be accomplished to Logical Printer1.
Advanced > Protocols > Netware
This printing system supports both NDS and bindery printing in either print server mode
or remote printer mode.
NetWare setup requires installation of the following client software and logon with
Administrator Privileges. If you are unsure, please contact your network administrator.
With Novell Client, creation of the NetWare print objects with the AdminManager
NetWare Setup Wizard requires the NetWare Client from Novell. For NetWare printing,
you may use the NetWare Client from either Novell or Microsoft.
For Admin Privileges, network operations (creating queues etc.) require 'admin' or
'supervisor' privileges (or equivalent). Certain portions of AdminManager may be
inoperable if you attempt those operations without sufficient privileges.
Item Description
TCP/IP Port
Number
Specifies the port number for the logical printer as well as
the TCP raw port number (9100, etc.). Conversion is applied
to data that is input to the specified raw port in accordance
with the selected logical printer. This port is invalid if it is
given a port number that is the same as that of an already
specified port (e.g. FTP or LPD).
Bi-directional
Printing
On or Off Bi-directional Printing using the TCP/IP raw port.
With this setting Off, all send data are discarded.
In order to have the data that is received from the printer
returned to the client when printing with PostScript, PJL and
other such commands, it is necessary to On bi-directional
printing.
Start of Job
String
Specifies the character string sent to the printer before
output directly to the output port (lp port). Specifies the
character string if it is necessary to transmit the control code
before printing.
End of Job
String
Specifies the character string sent to the printer after directly
outputting to the output port (lp port). Specify a character
string, if it is necessary, to send a control code after printing.
Item Description
NetWare
Protocol
Enables or disables the Network Protocol.
Bindery Mode
Enables or disables Bindery Mode.
Frame Type
Sets the Frame type. You can choose from Auto, 802.3,
Ethernet-II, SNAP or 802.2.
File Server
(Primary)
Enter the name of the primary File Server.
NDS Tree
Enter the name of the NDS Tree.