System information

COMMAND CENTER Pages
Operation Guide 47
user’s settings on the basic page, and the user's document box and shared document
box pages.
Advanced > Management > Notification/Maintenance > Maintenance
Notification
This feature defines the recipient of maintenance information reports.
Advanced > Management > Maintenance Notification > Job Log
Notification
This feature defines the Job Log Notification information reports.
Item Description
Equipment ID
This is the name by which the machine will be identified.
Recipient
Address
The E-mail address of the recipient. If there is more than one
recipient then the addresses should be separated by a semi-
colon ";".
Subject
You can include model name, serial number, MAC address
and equipment ID in the subject line as follows: Enter one of
the following conversion strings starting with %. The string
will be converted into a pre-defined string to display the
above information.
- %printer = Model
- %serial = Serial Number
- %etheraddr = MAC Address
- %equipid = Equipment ID
E-mail Interval
Sets the time or interval for sending the status information.
Events will be reported at the specified interval.
• None: No report is sent.
• Monthly: Sends on the specified day of specified month.
• Weekly: Sends on the specified day of every week.
• Daily: Sends at the specified time of every day.
• Hourly: Sends at the specified interval every hour.
If a specified day does not exist in the month, such as the
31st, the last day of the month is used as the specified day.
Run once now
You can test this by clicking the Send button to immediately
send a report.
Item Description
Recipient
Address
The E-mail address of the recipient. If there is more than one
recipient then the addresses should be separated by a semi-
colon ";".
Subject
You can include model name, serial number, and MAC
address in the subject line as follows: Enter one of the
following conversion strings starting with %. The string will be
converted into a pre-defined string to display the above
information.
- %printer = Model
- %serial = Serial Number
- %etheraddr = MAC Address