Installation guide

10-14
Troubleshooting > Responding to Messages
Cannot duplex print on the
following paper.*
Did you select a paper size/
media type that cannot be duplex
printed?
Press [Paper Selection] to select the
available paper.
Press [Continue] to print without using
Duplex function.
4-8
Cannot offset the following
paper.*
Did you select a paper size/
media type that cannot be offset?
Press [Paper Selection] to select the
available paper.
Press [Continue] to print without using
Offset function.
3-44
Cannot print the specified
number of copies.*
– Only one copy is available. Press
[Continue] to continue printing. Press
[Cancel] to cancel the job.
The machine may reproduce the same
originals by arranging the following
settings:
- Uncheck [RAM Disk] in the [Device
Settings] tab of the printer's properties.
NOTE: If you unchecked the [RAM
Disk], check the [RAM Disk] again
after the printing is completed. If
not, print speed may be reduced.
—
Do you want to print the data
stored in the USB memory?
Only one copy is available. Press
[Continue] to continue printing. Press
[Cancel] to cancel the job.
The machine may reproduce the same
originals by arranging the following
settings:
-Reduce the number of copies to be
printed at once.
Furthermore, the machine may
reproduce the same originals by
arranging the following settings:
- Select [Copy Priority] of Optional
Memory in System Menu.
NOTE: Before changing the
Optional Memory setting, contact
your administrator.
9-24
Cannot process this job.* — This job is canceled because it is
restricted by User Authorization or Job
Accounting. Press [End].
—
Cannot staple at the specified
position.
Have you selected a position that
cannot be stapled?
Press [Paper Selection] to select the
available paper.
Press [Continue] to print without using
Staple function.
—
Cannot staple the following
paper.*
Did you select a paper size/type
that cannot be stapled?
Press [Paper Selection] to select the
available paper.
Press [Continue] to print without using
Staple function.
—
Cassette # failure. — Contact your Service Representative.
Press the System Menu/Counter key,
[Adjustment/Maintenance], [Service
Setting] and then [Enable Repaired
Unit]. Press [Execute] to perform Enable
Repaired Unit.
—
Message Checkpoints Corrective Actions Reference
Page