Printer User's Manual

Using the Operator Panel

ADVANCED OPERATION GUIDE 2-31

Pressing U or V toggles through the serial parameters as follows. To

change the serial parameter, press [OK] ([ENTER]). Use U or V to

change the value or selection.

For example, to change baud rate from

9600 to 115200, display the baud rate

menu following the above procedure. When

the display shows baud rate, 9600 (bps),

press [OK] ([ENTER]). A blinking question

mark (?) appears.

Press U or V to scroll through values. When 115200 is displayed, press

[OK] ([ENTER]). Press [MENU] to exit the menu selection.

NOTE: Some computers may not be able to handle a baud rate of

115200 bps. If you set the baud rate to 115200 and encounter

communication problems, select a lower baud rate.

Range

>Baud Rate

9600

1200, 2400, 4800, 9600 (Default),

19200, 38400, 57600, 115200

>Data Bits

7 or 8 (Default)

>Stop Bits

1 (Default) or 2

>Parity

None

None (Default), Odd, Even, or Ignore

>Protocol

DTR(pos.)&XON

DTR(pos.)& Xon (Default),

DTR(positive), DTR(negative),

XON/XOFF, or ETX/ACK

>Baud Rate

? 9600