User's Manual

iBurst Terminal, Desktop Model (UTD) / USB Model (UTU), Manual

Kyocera Corporation Revision 1.01 --- June.08.2006

- 14 -

iBurst Software Installatio

iBurst Software InstallatioiBurst Software Installatio

iBurst Software Installation

n n

This section shows the procedure to install iBurst software on your PC for utilizing iBurst

Terminal. The procedure shall be done once before using it.

Installati

InstallatiInstallati

Installation for Windows XP

on for Windows XPon for Windows XP

on for Windows XP

NOTE:

If you are going to connect the iBurst Terminal with your PC only through an Ethernet cable, not

through a USB cable, you don’t need to install/uninstall any iBurst software. In such case, you

can skip this section and you need only to create a dial-up connection setting described at from

page 62. You can see indications of the iBurst Terminal over Ethernet. See page 87 for the

method.

1. Make sure to disconnect the iBurst Terminal with your PC.

ATTENTION:

Don

DonDon

Don’

’’

’t connect the iBurst Terminal with your PC through a USB cable until completion of

t connect the iBurst Terminal with your PC through a USB cable until completion of t connect the iBurst Terminal with your PC through a USB cable until completion of

t connect the iBurst Terminal with your PC through a USB cable until completion of

installation.

installation.installation.

installation.

2. Turn your PC on.

3. Insert the Software Utility CD provided by the network operator into your CD-ROM drive; or

execute the appropriate installation software.

4. iBurst Terminal Setup starts. Click the [Next >] button.