User's Manual

iBurst Terminal, Desktop Model (UTD) / USB Model (UTU), Manual

Kyocera Corporation Revision 1.01 --- June.08.2006

- 22 -

9. Click the [Finish] button.

10. Click the [OK] button.

NOTE: Refer to the 1st article in chapter 6, if you face such symptom described in the

attention message.

NOTE:

If you are going to connect the iBurst Terminal with your PC only through an Ethernet cable, not

through a USB cable, you can skip from hear to step 18 and continue from step 19 in this section.

You can see indications of the iBurst Terminal over Ethernet. See page 87 for the method.

11. Connect the iBurst Terminal with your PC through a USB cable.

Windows will detect the iBurst Terminal as a new hardware so that [Add New Hardware

Wizard] will begin.