User's Manual

iBurst Terminal, Desktop Model (UTD) / USB Model (UTU), Manual

Kyocera Corporation Revision 1.01 --- June.08.2006

- 89 -

1) Click “Start” -> “Settings” -> “Control Panel” to open that.

2) Double click “Network and Dial-up Connections” to open that.

3) Double click the connection of the Ethernet port you want to use. In general case, the

name should be “Local Area Connection”. A properties dialog will appear.

4) On “General” tab in the dialog, select “Internet Protocol (TCP/IP)” and click “Properties”

button. “Internet Protocol (TCP/IP) Properties” dialog will appear.

5) On “General” tab in the dialog, select “Use the following IP address:” and specify IP address

and Subnet Mask according to your network plan. In case of connecting directly between

the iBurst Terminal and your PC, the settings shown below are recommended as an

example.

IP address: 192.168.250.1

Subnet mask: 255.255.255.0

Default gateway: (blank)

6) Click “OK” to close the TCP/IP properties.

7) Click “OK” to close the Ethernet Connection properties.

8) Close “Network and Dial-up Connections” window.

1) Click “Start” -> “Settings” -> “Control Panel” to open that.

2) Double click “Network” to open that.

3) On “Configuration” tab in the dialog, select “TCP/IP -> [the name of the network

adapter/card]” and click “Properties” button. “TCP/IP Properties” dialog will appear.

4) On “IP Address” tab in the dialog, select “Specify an IP address:” and specify IP address and

Subnet Mask according to your network plan. In case of connecting directly between the

iBurst Terminal and your PC, the settings shown below are recommended as an example.

IP address: 192.168.250.1

Subnet mask: 255.255.255.0

Default gateway: (blank)

5) Click “OK” to close the TCP/IP properties.

6) Click “OK” to close “Network” dialog.