Operation Manual

CHAPTER 2 NAMES OF PARTS
2-2
1 Original cover
(Open/close to set the original on the platen.)
2 Operation panel
(Contains the keys and indicators for operating the copier.)
3 Left cover handle
(Hold to open the left cover.)
4 Left cover
(Open when a paper misfeed occurs.)
5 Multi-Bypass
(Load paper here when copying onto small-size or special paper.)
6 Insert guides
(Align the guides with the paper width when loading paper on the
multi-bypass.)
7 Support guide
(Pull out when loading paper into the multi-bypass.)
8 Toner container
9 Waste toner tank
0 Cleaning shaft
(Pull out and push back in several times after toner container
replacement or when copy images are soiled with toner.)
! Front cover
(Open to replace the toner container and waste toner tank.)
@ Main switch
(Turn ON (|) before starting to make copies.)
# Copy storage section
(Copied paper is stored here.)
$ Drawer
(Holds up to 250 sheets of standard paper [standard paper as
specified by our company].)
% Platen
(Set originals here for copying. Place originals face-down with the
edges aligned with the size scales on the left and rear sides of the
platen.)
^ Original size scales
(Be sure to align the original with these when setting the original
on the platen.)
& Length guide
(Adjust to the length of the paper to be set in the drawer.)
* Width guide
(Adjust to the width of the paper to be set in the drawer.)
( Width adjustment lever
(Hold the lever and adjust the width guide to the width of the paper
to be set in the drawer.)
) Length guide storage section
(Store the length guide here when it is not used.)
Drawer bottom plate
(Push down when loading paper.)
¤ Handles for transport
(The handles are located on the right and left sides of the copier.
Hold these two handles when moving the copier.)