Operation Manual
Table Of Contents
- Energy Star Program
- Please read this Operation Guide before using the copier. Keep it close to the copier for easy re...
- Section 1 IMPORTANT! PLEASE READ FIRST.
- Section 2 NAMES OF PARTS
- Section 3 PREPARATIONS
- Section 4 BASIC OPERATION
- Section 5 COPY FUNCTIONS
- Making 2-Sided copies from various types of originals
- Copying two-page originals onto separate sheets: Page Separation/Split Copy Modes
- Making a margin space on the copies
- Making copies with clean edges
- Fitting the image of either two or four originals onto a single copy page
- Automatic Sorting of copy sets
- Saving on toner use
- Memorizing frequently used settings: Program Function
- Section 6 COPIER MANAGEMENT
- Copy Management Mode
- Department Management Modes
- Department Management Code Operations Procedures
- Department Code Registration
- Deleting Department Codes
- Clearing the Department Management Count
- Outputting the Department Management List
- How to set the Department Management Mode
- Making copies when the copier is in the Department Management Mode
- Default Setting Mode
- Checking the Total Counter and Printing Out the Counter Report
- Copy Management Mode
- Section 7 OPTIONAL EQUIPMENT
- Section 8 TROUBLESHOOTING
- Section 9 MAINTENANCE AND OPERATION INFORMATION
- Appendix: Functions and Settings Combination Chart
Section 5 COPY FUNCTIONS
5-6
Standard Margin
[Inch specifications]
The position of the image of the original is shifted for copying and a
0.13/0.25/0.38/0.50/0.63/0.75 (") (1/8-inch increments) width
binding margin created.
[Metric specifications]
The position of the image of the original is shifted for copying and a
1 to 18 mm (1 mm increments) width binding margin created.
Note
If the left width of the Binding Margin is set when
setting the 2-Sided Copy, the right side of the Binding
Margin will be set automatically for the reverse side by
the 2-sided copy rotational setting in the case where it is
rotated.
1 Set the original.
IMPORTANT!
Place the original so that the side to be set for the Margin
shift is on the right side (on the left side, in the case of
the optional Document Processor) and check its position
after setting it. If the original is placed in the wrong
direction, the Binding Margin will not be produced in the
position set.
Note
The Binding Margin can also be set in the Default
Settings Mode. (Refer to P.6-25 "Margin Shift".)
The value set in the Default Setting Mode will inherit the
value that is set at the time when the copy is made.
2 Press the [Margin] key.
The Margin Shift display will light up.
3 Press the [Start] key.
The copier will begin copying.
Setting the Margin
Use the procedure given below to change the Margin.
1 Press the [Margin] key for 3 seconds. The Default Settings
Mode for the Margin will be displayed.
Making a margin space on the copies
Original Copy