Operation Manual
Table Of Contents
- Energy Star Program
- Please read this Operation Guide before using the copier. Keep it close to the copier for easy re...
- Section 1 IMPORTANT! PLEASE READ FIRST.
- Section 2 NAMES OF PARTS
- Section 3 PREPARATIONS
- Section 4 BASIC OPERATION
- Section 5 COPY FUNCTIONS
- Making 2-Sided copies from various types of originals
- Copying two-page originals onto separate sheets: Page Separation/Split Copy Modes
- Making a margin space on the copies
- Making copies with clean edges
- Fitting the image of either two or four originals onto a single copy page
- Automatic Sorting of copy sets
- Saving on toner use
- Memorizing frequently used settings: Program Function
- Section 6 COPIER MANAGEMENT
- Copy Management Mode
- Department Management Modes
- Department Management Code Operations Procedures
- Department Code Registration
- Deleting Department Codes
- Clearing the Department Management Count
- Outputting the Department Management List
- How to set the Department Management Mode
- Making copies when the copier is in the Department Management Mode
- Default Setting Mode
- Checking the Total Counter and Printing Out the Counter Report
- Copy Management Mode
- Section 7 OPTIONAL EQUIPMENT
- Section 8 TROUBLESHOOTING
- Section 9 MAINTENANCE AND OPERATION INFORMATION
- Appendix: Functions and Settings Combination Chart
![](/manual/kyocera/km2020/operation-manual-english/images/img-48.png)
Section 5 COPY FUNCTIONS
5-12
The directions for setting the original and the finished copy are as
follows.
<When the original is set on the platen>
<When the original is set in the Document Processor>
1 Set the original.
Note
The 4 in 1 layout setting (refer to P.6-26 "4 in 1 Layout
Order") and the setting of border lines when setting
merge copies (refer to P.6-27 "Merge Copy Borderline")
can also be set in the Default Setting Mode.
The value set in the Default Setting Mode will inherit the
value that is set at the time when the copy is made.
2 Press the [Combine/Merge Copy] key to light up either the
“2 in 1” or “4 in 1” display.
3 Input the number of sets of copies using the keypad.
4 Press the [Start] key.
The copier will begin reading in the original.
When an original has been set in the optional Document
Processor copying will begin automatically.
When the original has been set on the platen and the
scanning of the original completed, “1-” (No. of Originals
Read In) is displayed and the Combine/Merge Copy display
blinks. When this occurs, carry out the following procedure.
Inch specifications Metric specifications
5 Replace the original with the next one and press the [Start]
key.
The copier will read in the original.
Original Setting Direction Finished Product
Original Setting Direction Finished Product
1
1
1
1
1
1
1
1
1
1