Operation Manual
Table Of Contents
- Energy Star Program
- Please read this Operation Guide before using the copier. Keep it close to the copier for easy re...
- Section 1 IMPORTANT! PLEASE READ FIRST.
- Section 2 NAMES OF PARTS
- Section 3 PREPARATIONS
- Section 4 BASIC OPERATION
- Section 5 COPY FUNCTIONS
- Making 2-Sided copies from various types of originals
- Copying two-page originals onto separate sheets: Page Separation/Split Copy Modes
- Making a margin space on the copies
- Making copies with clean edges
- Fitting the image of either two or four originals onto a single copy page
- Automatic Sorting of copy sets
- Saving on toner use
- Memorizing frequently used settings: Program Function
- Section 6 COPIER MANAGEMENT
- Copy Management Mode
- Department Management Modes
- Department Management Code Operations Procedures
- Department Code Registration
- Deleting Department Codes
- Clearing the Department Management Count
- Outputting the Department Management List
- How to set the Department Management Mode
- Making copies when the copier is in the Department Management Mode
- Default Setting Mode
- Checking the Total Counter and Printing Out the Counter Report
- Copy Management Mode
- Section 7 OPTIONAL EQUIPMENT
- Section 8 TROUBLESHOOTING
- Section 9 MAINTENANCE AND OPERATION INFORMATION
- Appendix: Functions and Settings Combination Chart
Section 5 COPY FUNCTIONS
5-13
6 If there are no more originals, press either the
[Combine/Merge Copy] key or the [Enter] key.
The copier will begin copying.
4 in 1 Layout Order
Follow the procedure below to change the order in which pages are
to be laid out within the copied page when making 4 in 1 copies.
1 Depress the [Combine/Merge Copy] key for 3 seconds. The
Default Settings Mode will be displayed.
2 Confirm that the “F28 (4 in 1 layout setting)” is displayed
and then press the [Enter] key.
Inch specifications Metric specifications
3 Press either the Zoom (+) key or the Zoom (–) key and select
the layout order from “1-” to “4-”.
The order of the layouts displayed is as below.
IMPORTANT!
When the orientation is “Portrait” (vertical) select 1 or 2;
when it is “Landscape” (horizontal) select 3 or 4.
4 Press the [Enter] key.
The display will blink and copying can be begun.
Inch specifications Metric specifications
Setting the Merge Copy Border Lines
Use the procedure given below to change the Merge Copy Border
Lines.
1 Depress the [Combine/Merge Copy] key for 3 seconds. The
Default Settings Mode will be displayed.
1
1
3
4
2
4
2
3
3-:
1-:
1
1
2
4
3
4
3
2
4-:
2-: