Operation Manual
Table Of Contents
- Energy Star Program
- Please read this Operation Guide before using the copier. Keep it close to the copier for easy re...
- Section 1 IMPORTANT! PLEASE READ FIRST.
- Section 2 NAMES OF PARTS
- Section 3 PREPARATIONS
- Section 4 BASIC OPERATION
- Section 5 COPY FUNCTIONS
- Making 2-Sided copies from various types of originals
- Copying two-page originals onto separate sheets: Page Separation/Split Copy Modes
- Making a margin space on the copies
- Making copies with clean edges
- Fitting the image of either two or four originals onto a single copy page
- Automatic Sorting of copy sets
- Saving on toner use
- Memorizing frequently used settings: Program Function
- Section 6 COPIER MANAGEMENT
- Copy Management Mode
- Department Management Modes
- Department Management Code Operations Procedures
- Department Code Registration
- Deleting Department Codes
- Clearing the Department Management Count
- Outputting the Department Management List
- How to set the Department Management Mode
- Making copies when the copier is in the Department Management Mode
- Default Setting Mode
- Checking the Total Counter and Printing Out the Counter Report
- Copy Management Mode
- Section 7 OPTIONAL EQUIPMENT
- Section 8 TROUBLESHOOTING
- Section 9 MAINTENANCE AND OPERATION INFORMATION
- Appendix: Functions and Settings Combination Chart
Section 5 COPY FUNCTIONS
5-18
Copy settings that are frequently used can be registered and then
recalled up by pressing the [Program] key. Even types of copies can
be stored.
Registering a program
1 Set the Copy Mode to be registered.
2 Press the [Program] key for 3 seconds.
3 Input the program number (0 to 9) using the Keypad and
press the key for 3 seconds.
The display of the number input will blink 2 times and the
program will be registered.
Note
If the same number as a program already registered is
input, the prior program is overwritten.
Using programmed setting to make
copies
1 Press the [Program] key.
2 Press either the Zoom (+) or Zoom (–) key, select the
number of the program to be called and then press the
[Enter] key. Input can also be done using the Keypad.
Inch specifications Metric specifications
3 Set the original and press the [Start] key.
The copy will be made using the program that has been set.
Memorizing frequently used settings: Program Function