Operation Manual
Table Of Contents
- Energy Star Program
- Please read this Operation Guide before using the copier. Keep it close to the copier for easy re...
- Section 1 IMPORTANT! PLEASE READ FIRST.
- Section 2 NAMES OF PARTS
- Section 3 PREPARATIONS
- Section 4 BASIC OPERATION
- Section 5 COPY FUNCTIONS
- Making 2-Sided copies from various types of originals
- Copying two-page originals onto separate sheets: Page Separation/Split Copy Modes
- Making a margin space on the copies
- Making copies with clean edges
- Fitting the image of either two or four originals onto a single copy page
- Automatic Sorting of copy sets
- Saving on toner use
- Memorizing frequently used settings: Program Function
- Section 6 COPIER MANAGEMENT
- Copy Management Mode
- Department Management Modes
- Department Management Code Operations Procedures
- Department Code Registration
- Deleting Department Codes
- Clearing the Department Management Count
- Outputting the Department Management List
- How to set the Department Management Mode
- Making copies when the copier is in the Department Management Mode
- Default Setting Mode
- Checking the Total Counter and Printing Out the Counter Report
- Copy Management Mode
- Section 7 OPTIONAL EQUIPMENT
- Section 8 TROUBLESHOOTING
- Section 9 MAINTENANCE AND OPERATION INFORMATION
- Appendix: Functions and Settings Combination Chart
Section 6 COPIER MANAGEMENT
6-11
Default Settings Mode Operations
Procedures
Follow the procedure listed below to operate in the [Default
Settings Mode].
1 Depress the [Exposure Adjustment] keys on both sides for 3
seconds. “F00 (Default Settings Mode)” will be displayed in
the No. of Copies display.
2 Press either the Zoom (+) key or the Zoom (–) key and select
each Default Settings Mode.
Inch specifications Metric specifications
Notes
• Each of the Default Setting Modes can be selected by
pressing the Keypad keys.
• Refer to "Procedure for Changing the Default
Settings" regarding the following.
3 After completing each operation, press on the Zoom (+) or
Zoom (–) key to display “F00”.
Inch specifications Metric specifications
4 Press the [Enter] key. The mode display will return to the
No. of Copies display.
Inch specifications Metric specifications
Procedure for Changing the Default
Settings
The procedure for changing each of the items in the Default
Settings is described below.
User Status Report
Outputs a list of the values set for the Default Settings items.
Note
Check to make sure that 11" × 8 1/2"/A4 size paper is
loaded in the drawer.
1 Display the Default Settings Mode. (Refer to P.6-11
"Default Settings Mode Operations Procedures".)
Inch specifications Metric specifications
2 Press either the Zoom (+) or Zoom (–) key to display “F01”.
Inch specifications Metric specifications