Operation Manual
Table Of Contents
- Energy Star Program
- Please read this Operation Guide before using the copier. Keep it close to the copier for easy re...
- Section 1 IMPORTANT! PLEASE READ FIRST.
- Section 2 NAMES OF PARTS
- Section 3 PREPARATIONS
- Section 4 BASIC OPERATION
- Section 5 COPY FUNCTIONS
- Making 2-Sided copies from various types of originals
- Copying two-page originals onto separate sheets: Page Separation/Split Copy Modes
- Making a margin space on the copies
- Making copies with clean edges
- Fitting the image of either two or four originals onto a single copy page
- Automatic Sorting of copy sets
- Saving on toner use
- Memorizing frequently used settings: Program Function
- Section 6 COPIER MANAGEMENT
- Copy Management Mode
- Department Management Modes
- Department Management Code Operations Procedures
- Department Code Registration
- Deleting Department Codes
- Clearing the Department Management Count
- Outputting the Department Management List
- How to set the Department Management Mode
- Making copies when the copier is in the Department Management Mode
- Default Setting Mode
- Checking the Total Counter and Printing Out the Counter Report
- Copy Management Mode
- Section 7 OPTIONAL EQUIPMENT
- Section 8 TROUBLESHOOTING
- Section 9 MAINTENANCE AND OPERATION INFORMATION
- Appendix: Functions and Settings Combination Chart
Section 6 COPIER MANAGEMENT
6-23
5 Press the [Enter] key.
The display will return to that of Step 2.
Inch specifications Metric specifications
Custom Size (1 to 2)
Set the Custom Size.
The setting of Custom Size 1 is shown here as an example. To set
Custom Size 2 select F23 in the Default Settings Mode and then
perform the same settings.
1 Display the Default Settings Mode. (Refer to P.6-11
"Default Settings Mode Operations Procedures".)
Inch specifications Metric specifications
2 Press either the Zoom (+) or Zoom (–) key to display “F22”.
Inch specifications Metric specifications
3 Press the [Enter] key.
Inch specifications Metric specifications
4 Press either the Zoom (+) key or the Zoom (–) key and select
the size.
InP (Irregular Size) When selecting Irregular Sizes, carry
out the following procedure. In the case of the selection of
other sizes, proceed to Step 9.
Inch specifications Metric specifications
5 Press the [Enter] key.
Inch specifications Metric specifications
6 Press either the Zoom (+) or Zoom (–) key and input the
Length Size (Y Direction) in inch/mm units.
Inch specifications Metric specifications
7 Press the [Enter] key.
Inch specifications Metric specifications