Operation Manual
Table Of Contents
- Energy Star Program
- Please read this Operation Guide before using the copier. Keep it close to the copier for easy re...
- Section 1 IMPORTANT! PLEASE READ FIRST.
- Section 2 NAMES OF PARTS
- Section 3 PREPARATIONS
- Section 4 BASIC OPERATION
- Section 5 COPY FUNCTIONS
- Making 2-Sided copies from various types of originals
- Copying two-page originals onto separate sheets: Page Separation/Split Copy Modes
- Making a margin space on the copies
- Making copies with clean edges
- Fitting the image of either two or four originals onto a single copy page
- Automatic Sorting of copy sets
- Saving on toner use
- Memorizing frequently used settings: Program Function
- Section 6 COPIER MANAGEMENT
- Copy Management Mode
- Department Management Modes
- Department Management Code Operations Procedures
- Department Code Registration
- Deleting Department Codes
- Clearing the Department Management Count
- Outputting the Department Management List
- How to set the Department Management Mode
- Making copies when the copier is in the Department Management Mode
- Default Setting Mode
- Checking the Total Counter and Printing Out the Counter Report
- Copy Management Mode
- Section 7 OPTIONAL EQUIPMENT
- Section 8 TROUBLESHOOTING
- Section 9 MAINTENANCE AND OPERATION INFORMATION
- Appendix: Functions and Settings Combination Chart
Section 6 COPIER MANAGEMENT
6-34
The Total Count can be viewed on the Operation Panel. A Counter
Report can also be output.
1 Depress the [Stop/Clear] key for 3 seconds. The Copy Count
will be displayed on the No. of Copies display.
2 The Copy Count will be displayed three times in the
following order. (The example shows a copy count of 1234
copies.)
Note
Pressing on the [Start] key while the Copy Count is
displayed will output the Counter Report. Check to make
sure that 11" × 8
1/2"/A4 paper is available in the drawer
before printing out the Counter Report.
Sample: Counter Report
3 The copier will return to the state where copying can be
continued after the Copy Count has been displayed.
Inch specifications Metric specifications
Checking the Total Counter and Printing Out the Counter Report
1
2 3