Operation Manual

CHAPTER 5 FUNCTIONS
5-17
Touch the [Cover] key.
The selection screen of the front cover and the back
cover will appear.
Select the copying conditions of the front cover and the
back cover.
Press the [Start] key.
Scanning will start.
When originals are set in the Document Processor, copy-
ing will start after scanning the set originals.
When an original is set on the platen, a message for
scanning the next original appears. Go to the next step.
Replace the original and then press the [Start] key.
Scanning will start.
When all originals are scanned, touch the [Scanning fin-
ished] key. Copying will start.
Touch the [Booklet] key.
The original/finish set-up screen will appear.
Select the type of original and finishing.
When the optional document finisher with the center
staple function is installed, the [Center Staple] key is dis-
played, allowing the center staple of up to 10 sheets (40
pages).
Touch the [Stitching Front cvr] key.
The “Stitching Front Cvr” screen will be appear.
If the front cover is not used, proceed to step 9.
6
7
5
4
8
Start
Stop/
Clear
Reset
1 2 3
4
5 6
7
8 9
0
Inch specifications
Metric specifications
Inch specifications
Metric specifications
9
10
11
Inch specifications
Metric specifications